The Ultratec TDD DetectorInstallation InstructionsUltratec, Inc.450 Science DriveMadison, WI 53711BOOKTD31
To set up your TDD Detector for AutomaticLoop Current Detection you must open the caseby removing the four screws in the bottom ofthe case. Move Jumpe
the jack labeled "LINE" on the back panel ofyour TDD Detector. Plug the other end of thephone wire into the telephone line outlet. If you ha
91. Check your phone line.Pick up the receiver of a telephone connected toa line that the TDD Detector is monitoring. Listen to the dial tone on the l
105. If you are using an external speaker tobroadcast the voice, type the [#][#][2]TEST command, and adjust the "VOLUME"control as the voice
deaf community in your area to speak with youroperators can help them to become sensitive toand aware of the special communicationproblems faced by pe
13• Rack installation. You can order yourTDD Detectors for installation in yourtelephone equipment rack. Order onecard in the rack for each line you w
Ultratec offers 24-hour replacementservice for your TDD Detector…• If your TDD Detector needs repair orservice, Ultratec can send a replacementor &quo
TESTING PROCEDURES:All TDD Detectors go through extensive testingprocedures as part of Ultratec's quality controlprogram. These procedures includ
FRONT PANEL:TTY SIGNAL Off when monitoring the phoneline. On when TTY charactersare detected. Blinking after voiceand TTY messages have beensent.RESET
NOTICEAll efforts have been made to insure the accuracy of the contents of this manual. However,Ultratec, Inc., can assume no responsibility for any e
Appendix ATDD Detector Rack InstallationEquipment Needed:ScrewdriverTwo 50-pin, male, micro-ribbon connectorsProcedure:1. Install the Ultratec TDD Det
7. Press the Send (Red) Button and the Send LED will turn on. Youhave now tested the rack for correct wiring of the power supply andAuto/Manual mode s
TDD Detector Installation Test1. Place the operator's headset or telephone in an Off-Hook conditionand listen for dial tone. There should be no d
FCC InformationYour TDD Detector complies with the regulations for aClass A computing device as specified in Subpart J ofPart 15 of the FCC Rules. The
Contents1 About TTYs and the TDD Detector1 About TTYs and the Deaf TTY Network1 The Ultratec TDD Detector announces incoming TTY calls2 Control from a
The deaf telecommunications network began inthe early 1960's. Surplus Teletype machinesbecame available, and a deaf physicist namedRobert Weitbre
Although it is connected to your phone line, theTDD Detector does not affect the normaloperation of your telephone equipment. NOTE: If your installati
Read the descriptions of the manual andautomatic reset installations below, andselect the installation that is best for yoursetting. Then turn to the
The Ultratec TDD Detector uses two built-inRJ12C telephone modular jacks to connectdirectly to the telephone and the telephone line.These jacks are lo
54. Connect the AC adapter.Plug the AC adapter wire into the "POWER" jackon the back panel of your TDD Detector.Plug the AC adapter into an
3. Connect the operator's telephone to theTDD Detector.Plug the phone wire from the operator'stelephone into the "TELEPHONE" jack
Kommentare zu diesen Handbüchern